Step 5. (Optional) Secure the server to the rack.
a. Install one M6 screw to each of the rails to secure the server to the rear of the rack.
Rack rear
Figure 28. Securing the server to the rear of the rack
b. Secure the server to the front of the rack. Fasten the two 2 thumbscrews located on the 1
rack latches.
Rack front
Figure 29. Securing the server to the front of the rack
After you finish
1. Reconnect the power cords and any cables that you removed.
2. Power on the server and any peripheral devices. See “Power on the server” on page 68.
3. Update the server configuration. See
“Complete the parts replacement” on page 246.
76
ThinkSystem SR630 V3 User Guide
To Next Page
Loading...
