Lenze 8400 StateLine C - Page 27

Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011 L 27
8400 StateLine C | Reference manual
Introduction: Parameterising the controller
[2-1] Adjustment of the drive solution per parameter setting
 Signal inputs for control and setpoint signals
 Signal flow of the integrated technology application (see the following subchapter)
 Signal outputs for status and actual value signals
M
...
M
n
t
è
ç
02
1
Switch-off positioning
Actuating drive speed
Setpoint
generator
Process
controller
Motion
Control
Kernel
Device
control
Motor
control
Signal
inputs
Signal
outputs
Parameterisation
Fieldbus
L-force EASY Starter
L-force Engineer
Keypad
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com