Lenze 8400 StateLine C - Auto-Start Option Inhibit at Lenze Setting

Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011 L 99
8400 StateLine C | Reference manual
Device control (DCTRL)
Automatic restart after mains connection/fault...
4.3.2 Auto-start option "Inhibit at Lenze setting"
This function extension is available from version 06.00.00!
The "Inhibit at Lenze setting" auto-start option configurable via bit 4 of C00142
prevents
the change to the "SwitchedOn
" status after the Lenze setting has been loaded and the
controller is enabled.
For a change to the "SwitchedOn
" status, the controller enable must first be deactivated
after the Lenze setting has been loaded. Only if the controller is enabled again afterwards,
the status changes to "OperationEnabled
":
[4-2] Example 1: Behaviour with activated auto-start option "Inhibit at Lenze setting" (C00142: Bit 4 = "1")
[4-3] Example 2: Behaviour with deactivated auto-start option "Inhibit at Lenze setting" (C00142
: Bit 4 = "0")
n Loading of the Lenze setting not possible since controller inhibit not set.
o Controller inhibit via signal change by the user
p Loading of the Lenze setting via device command C00002/1
= "1"
q Controller enable via signal change by the user
r Controller inhibit and subsequent controller enable via signal change by the user
t
load
= time required for loading the Lenze setting
,QLW
5HDG\7R6ZLWFK2Q
6ZLWFKHG2Q
2SHUDWLRQ(QDEOHG


&
/$B1&WUOE&,QK
W
W


5)5
W


&
W
n
r
o
p
W
ORDG
q
n Loading of the Lenze setting not possible since controller inhibit not set.
o Controller inhibit via signal change by the user
p Loading of the Lenze setting via device command C00002/1
= "1"
q Controller enable via signal change by the user
t
load
= time required for loading the Lenze setting
,QLW
5HDG\7R6ZLWFK2Q
6ZLWFKHG2Q
2SHUDWLRQ(QDEOHG


&
/$B1&WUOE&,QK
W
W


5)5
W


&
W
W
n
o
p
ORDG
q
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com