8400 StateLine C | Reference manual
Working with the FB Editor
Copying an interconnection
770 L Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011
15.8 Copying an interconnection
In contrast to copying/inserting selected interconnection elements via the clipboard, the
function described in this chapter serves to replace the current FB interconnection of a
device completely
by the FB interconnection of another project device.
A complete interconnection comprises:
Function blocks (use and parameter values)
System blocks (application and parameter values)
Port blocks (use and parameter values)
Connections
Comments
Interconnection layout (arrangement of the modules)
Port definition of the ports used in the FB interconnection
How to copy the complete interconnection into another project device:
1. Select the application with the FB interconnection to be copied in the project view.
2. Select the command Application dataCopy FB interconnections....
3. Go to project view and select the application which is to be inserted into the copied
FB interconnection.
4. Select the command Application dataAdd FB interconnection....
• The command can only be activated if an FB interconnection has been copied
from a device of the same device type and version.
• After the command has been executed, the module assembly is compared. If
there are relevant deviations, the insertion is refused and a corresponding
message is displayed.
• If an insertion is possible, you are asked if the FB interconnection is to be
inserted.
5. Confirm the question if the copied FB interconnection is to be inserted with Yes.
• After the insertion, an update of the project is required.
Note!
The complete FB interconnection can only be copied between devices of the
same device type and version (e.g. 8400 HighLine C V1.0).
To Next Page
Loading...
