8400 StateLine C | Reference manual
Introduction: Parameterising the controller
General notes on parameters
36 L Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011
General operation
[2-2] Example: Change parameter with the keypad
Multilingualism
All texts displayed in the keypad are in English.
From version 11.00.00 onwards, the most important menus as well as diagnostic and
configuration parameters can are also available in German and French. To set a different
language, select the Language selection menu item in the main menu of the keypad.
1. Use the
/ navigation keys to select the
desired menu.
– Use the
/ navigation keys to reach a
higher/lower menu level.
– Use the
function key to return to the
main menu.
2. Use the
/ navigation keys to select the
parameter to be set within a submenu.
3. In order to select another subcode in case of
a parameter with subcodes:
– Press the navigation key
to change tot
he editing mode for the subcode.
– Use the navigation keys to set the
desired subcode.
4. Use the
function key to switch over to
the editing mode.
5. Use the navigation keys to set the desired
value.
6. Use the
function key to accept the
change and to leave the editing mode.
– Use the
function key to leave the
editing mode without accepting the
change.
The multilingual texts are stored in the
controller and do not have to be loaded into
the device.
For reasons of disc space, only the most
important menus and parameters as well
as the error messages are available in
several languages.
To Next Page
Loading...
