8400 StateLine C | Reference manual
Diagnostics & error management
Drive diagnostics via keypad/bus system
386 L Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011
9.4 Drive diagnostics via keypad/bus system
Keypad display of the controller status
When the keypad is connected to the diagnostic
interface X6 at the front of the controller, the status of
the controller is displayed via different symbols on the
LCD display in the area n.
Symbol Meaning Note
Controller is switched on. SwitchedOn
( 92)
Controller is enabled.
Application in the controller is stopped.
Quick stop is active
Controller is inhibited. The power outputs are inhibited.
Controller is ready to switch on. ReadyToSwitchOn
( 91)
Speed controller 1 in the limitation. The drive is torque-controlled.
Set current limit has been exceeded in motor
or generator mode.
Pulse inhibit is active The power outputs are inhibited.
System fault is active
Fault Fault
( 96)
Trouble Trouble
( 95)
TroubleQSP TroubleQSP
( 94)
Warning is active Warning
( 93)
To Next Page
Loading...
