8400 StateLine C | Reference manual
Commissioning
8400 commissioning wizard
52 L Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011
3.5 8400 commissioning wizard
This function extension is supported by the »Engineer« from version 2.15 onwards!
The 8400 commissioning wizard provides for a guided commissioning of the controller
based on the Lenze setting of the parameters. Then, the parameter settings made can be
stored save against mains failure in the controller.
How to carry out a guided commissioning with the »Engineer«:
1. In the Project view, select the 8400 StateLine controller.
2. Click the symbol to open the Commissioning wizard 8400.
Now, the commissioning wizard guides you step by step through the setting of the
essential parameters for quick commissioning.
Related topics:
Commissioning of the "Actuating drive speed" technology application
( 53)
Note!
Take all the necessary safety precautions before you carry out the following
commissioning steps and switch the device on!
Safety instructions with regard to commissioning
( 48)
To Next Page
Loading...
