8400 StateLine C | Reference manual
Commissioning
Commissioning of the "Actuating drive speed" technology application
54 L Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011
Saving parameter settings safe against mains failure ( 59)
Enable controller and test application
( 59)
3.6.1 Prepare controller for commissioning
1. Power connection wiring
– Refer to the mounting instructions supplied with the drive controller to find help on
how to correctly design the power connections to match the requirements of your
device.
2. Wire the control connections
– The assignment for your digital inputs should correspond to one of the
preconfigured control modes (C00007
) for terminal control:
3. Inhibit controller: Set terminal X4/RFR to LOW level or open contact.
4. Connect USB diagnostic adapter.
5. Switch on voltage supply of the controller.
– Without motor operation
: Connect external 24 V supply.
– With motor operation
: Connect mains voltage.
If the green "DRV-RDY" LED is blinking and the red "DRV-ERR" LED is off, the controller is
ready for operation and commissioning can proceed.
Related topics:
Automatic restart after mains connection/fault...
( 97)
LED status displays
( 381)
Assignment of the digital terminals
Control mode DI1 DI2 DI3 DI4
Terminals 0 JOG 1/3 JOG 2/3 DCB Cw/Ccw
Terminals 2 JOG 1/3 JOG 2/3 QSP Cw/Ccw
Terminals 11 Cw/Ccw DCB MPotUp MPotDown
Terminal 16 JOG 1/3 JOG 2/3 Cw/QSP Ccw/QSP
Abbreviations used:
JOG Selection of fixed setpoints 1 ... 3 parameterised in C00039/1...3
DCB Manual DC-injection braking
Cw/Ccw CW/CCW rotation
QSP Quick stop
MPotUp Motor potentiometer: Increase speed
MPotDown Motor potentiometer: Reduce speed
Cw/QSP Fail-safe speed selection with quick stop
Ccw/QSP
To Next Page
Loading...
