Lenze 8400 StateLine C

8400 StateLine C | Reference manual
I/O terminals
Analog terminals
280 L Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011
6.2.3 Internal interfaces | System block "LS_AnalogInput"
The LS_AnalogInput system block displays the analog input in the FB Editor.
6.2.4 Internal interfaces | System block "LS_AnalogOutput"
The LS_AnalogOutput system block displays the analog output in the FB Editor.
Output
Data type
Value/meaning
nIn1_a
C00033/1 | INT
Analog input 1
• Scaling:
±2
14
≡ ±10 V for use as voltage input
+2
14
≡ +20 mA for use as current input
bCurrentErrorIn1
BOOL
Status signal "Current input error"
• Only when analog input 1 is used as current input.
• Application: Cable-breakage monitoring of the 4 ...20 mA circuit.
TRUE |I
AIN1
| < 4 mA
/6B$QDORJ,QSXW
;
E&XUUHQW(UURU,Q
Q,QBD
$8
$5
$,
*$
28
&
&



'
$
&
2IIVHW *DLQ
& &
)LOWHUWLPH
&
&
&[
& (UURUUHDFWLRQ
Input
Data type
Information/possible settings
nOut1U_a
INT
Analog output 1
• Scaling: 2
14
≡ 16384 ≡ 10 V
/6B$QDORJ2XWSXW
Q2XWBD
&
2IIVHW*DLQ
&&
&
;
$8
$5
$,
*$
28
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com