8400 StateLine C | Reference manual
Working with the FB Editor
Reconfiguring the predefined interconnection
764 L Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011
The buttons serve to execute the following functions:
15.4.7 Resetting changed interconnection
If you only made changes on the I/O level, you can reset them by selecting a predefined
control scheme in C00007
. If you have also made changes on the application level, you
must first reset the changed application to a predefined application in C00005
.
How to reset the application interconnection to a predefined application:
1. Go to the Application parameters tab.
2. Select the required application in the Application list field.
How to reset the I/O interconnection to a predefined control scheme:
1. Go to the Application parameters tab.
2. Select the required control scheme in the Control source list field.
Button Function
Insert Add elements selected in the list to the target interconnection
• Only possible if at least one element in the list has been selected for insertion.
• Insertion is also possible via the <Enter> button if at least one element is selected from
the list for insertion.
• The original layout and the relative position of the inserted blocks to each other are
maintained.
• When copying across the devices, you also insert the corresponding separate technical
objects (e.g. port definition).
• The added elements are simultaneously deleted from the list. The connections are added
depending on the selected option.
Close Close dialog box.
• You can also use <Esc> or <Enter> to close the dialog box if "Insert" is not active.
• The elements inserted into the target interconnection so far are maintained.
• The connections for the blocks inserted so far are inserted depending on the selected
option.
To Next Page
Loading...
