Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011 L 37
8400 StateLine C | Reference manual
Introduction: Parameterising the controller
General notes on parameters
2.3.2 Change parameter settings with PC and Lenze software
The USB diagnostic adapter, for instance, can be used for the communication between the
PC (including the L-force »EASY Starter« or L-force »Engineer« software) and the controller,
see illustration. The USB diagnostic adapter is the connection between the PC (free USB
port) and the controller (diagnostic interface X6).
[2-3] Exemplary constellation for parameterising the controller
The All parameters tab in the »EASY Starter« and the »Engineer« provides a quick access to
all parameters of the controller.
The given categories and subcategories correspond 1:1 to the menus and submenus of the
keypad:
[2-4] All parameters tab in the »Engineer«
Moreover, the »Engineer« provides a commissioning interface on the Application
parameters tab where you can commission the application in a few steps.
Category
Subcategories
Detailed information on how to handle the »Engineer« can be found in the
integrated online help that you can call with the [F1] function key.
To Next Page
Loading...
