Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011 L 857
8400 StateLine C | Reference manual
Function library
System blocks | LS_AnalogInput
16.2.1 LS_AnalogInput
Interface to the analog input terminals.
16.2.2 LS_CANManagement
Control of internal functions of the CAN driver and display of the "Operational" status as
well as the node address.
16.2.3 LS_DataAccess
Only for Lenze-internal use.
16.2.4 LS_DeviceMonitor
Motor control status signals.
16.2.5 LS_DigitalInput
Interface to the digital input terminals.
16.2.6 LS_DigitalOutput
Interface to the digital output terminals.
For a detailed description see the main chapter "I/O terminals":
Internal interfaces | System block "LS_AnalogInput"
( 280)
For a detailed description see the main chapter "System bus CAN on board":
Internal interfaces | System block "LS_CANManagement"
( 499)
For a detailed description see the main chapter "Motor control (MCTRL)":
Internal status signals | system block "LS_DeviceMonitor"
( 251)
For a detailed description see the main chapter "I/O terminals":
Internal interfaces | System block "LS_DigitalInput"
( 266)
For a detailed description see the main chapter "I/O terminals":
Internal interface | System block "LS_DigitalOutput"
( 272)
To Next Page
Loading...
