Lenze 8400 StateLine C - Load Lenze Setting

8400 StateLine C | Reference manual
Device control (DCTRL)
Device commands (C00002/x)
78 L Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011
Short overview of device commands
Device commands described in this chapter:
Device commands described in other chapters:
C00002
Subcode:
Device command Controller
inhibit
required
Status information
1 Load Lenze setting
z dynamic
6 Load all parameter sets
z dynamic
11 Save all parameter sets
dynamic
16 Enable/Inhibit controller
static
17 Activate/Deactivate quick stop
static
19 Reset error
static
21 Delete logbook
static
27 Device search function
(from version 06.00.00)
static
C00002
Subcode:
Device command Controller
inhibit
required
Status information
23 Motor parameter identification
Automatic motor data identification
z dynamic
26 CAN reset node
Reinitialising the CANopen system bus interface
static
28 Check MasterPin
(from version 06.00.00)
Unlocking the controller with a MasterPin
z static
29 Set binding ID
(from version 06.00.00)
Device personalisation
static
30 Delete binding ID
(from version 06.00.00)
Device personalisation
static
31 Set password
(from version 06.00.00)
Password protection
static
32 Check password
(from version 06.00.00)
Password protection
static
33 Delete password
(from version 06.00.00)
Password protection
static
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com