Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011 L 405
8400 StateLine C | Reference manual
Diagnostics & error management
Error messages of the operating system
Error ID
8-bit value (0 ... 255) for error identification within the error subject area.
Tip!
All possible 16-bit error numbers are listed in the table "Short overview (A-Z)
" in the
second column.
( 407)
9.9.3 Reset error message
An error message with the response "Fault", "Trouble", "TroubleQSP" or "Warning locked"
must be explicitly reset (acknowledged) after the cause of the error has been eliminated.
To reset (acknowledge) a pending error message, execute the device command
C00002/19
="1".
Tip!
With an online connection to the controller, use the Diagnostics tab of the
»Engineer« and click Error reset to reset a pending error message.
27 Extension module slot 1 Errors that are reported by the extension module, and
communication errors to the plugged-in extension module.
Yes if it is a fieldbus error.
31 CAN integrated (general) Errors related to general CAN functions. Yes
35 CAN process data object (PDO) Errors that are explicitly only related to the CAN-PDO (process data
objects).
Yes
40 Device configuration Errors that occur due to incompatibilities of the plugged-in individual
components (fieldbus module, safety module, et al.).
Yes if the error relates to a
module plugged-in by the
user.
44 Parameter set Errors that occur in connection with the parameter set or the
parameter set memory (memory module).
Yes if the error relates to a
missing or incompatible
memory module.
45 Device firmware (internal error) Internal error of the device firmware. No
54 Fieldbus Errors that occur in connection with fieldbus communication. Yes
84 MotionControlKernel Errors that occur within the MotionControl basic functions (e.g.
profile generation, brake control, positioning).
Yes
100
...
103
User error 1
...
User error 4
Errors generated by the user (by the application) via the
LS_SetError_1
system block.
Yes
Error subject area Assigned errors Remedy possible by
user?
No. Name
To Next Page
Loading...
