Lenze i410 - Page 293

9095 0x2387 Imax: Clamp responded too oen Keypad display: Clamp
meout
Cause Remedy Error type/response
Maximum current of the axis (display in
0x2DDF:002) has been r
eached too oen in
succession.
•
Select a aer speed ramp.
•
Reduce the load.
•
Set Imax controller more dynamically.
Fault
Related topics
4Ima
x controller ^ 187
9096 0x2388 SL-PSM stall detecon acve Keypad display: SL-PSM s
tall det.
Cause Remedy Error type/response
Error message is not available for the inverter
i410.
Trouble
•
The in
verter is disabled immediately. The
motor has no torque (coasts).
9098 0x238A Maximum current reached Keypad display: Ima
x reached
Cause Remedy Error type/response
The current motor current 0x6078
(P103.00) is
equal to or higher than the max. overload
current 0x6073 (P324.00).
•
R
educe the load on the motor or change the
sengs for the maximum overload current.
0x6073
(P324.00)
Informaon
12576 0x3120 Mains phase fault Keypad display: Mains Phase f
ail
Cause Remedy Error type/response
Mains phase failure
•
Check wiring of the mains connecon.
•
Check fuses.
Fault
12672 0x3180 UPS
operaon acve Keypad display: UPS oper. acve
Cause Remedy Error type/response
Error message is not available for the inverter
i410.
Warning
12816 0x3210 DC bus overvoltage Keypad display: DC Bus O
V
Cause Remedy Error type/response
DC-bus voltage has exceeded the error
thr
eshold for overvoltage due to a too high
braking energy or a too high mains voltage. The
error threshold (display in 0x2540:006
(P208.06)) results from the seng of the rated
mains voltage in 0x2540:001 (P208.01).
•
R
educe dynamic performance of the load
prole.
•
Check mains voltage.
•
Check sengs for brake energy
manag
ement.
•
0x2541:001 (P706.01) = [0]: Connect brake
resistor to the power unit and acvate the
integrated brake chopper.
•
Reduce dynamic performance of the load
prole.
•
Check mains v
oltage.
•
Check
sengs for brake energy
management.
Fault
Related topics
4Mains v
oltage ^ 31
4Brake energy management ^ 228
Diagnoscs and fault eliminaon
Error codes, causes and remedies
293