Chapter 5 System Operation
92
890 USE 120 00
Procedure for Verifying System Operation
Overview The following procedure and associated information verifies operation of the
system without creating a hazard to personnel or jeopardizing the equipment. This
procedure presumes the drive has been configured with UniLink software in
OpMode 1 as a speed controller with analog input command.
Note: Default parameters for each Schneider Lexium BPH or SER series motor are
loaded into your drive at the factory and contain valid and safe values for the
current and speed controllers. A database for the servo motor parameters is stored
in the drive. During commissioning, you must select the data set for the connected
servo motor and store it in the drive. For most applications, these settings will
provide good servo loop efficiency. For a description of all parameters and motor
tuning, see the UniLink online help.
Continued on next page
To Next Page