113
Electrical Specifications - Power, continued
Bias Input
Specifications
Table
The following table provides 17D bias input specifications.
Note: The bias input also provides power to the optional motor brake.
Limit supply
values of the
servodrive
MHDA
associated with
a BHP motor
with brake
To take into account voltage drops caused by the Lexium MHDA
servodrive and
AGO FRU/AGO KIT supply cable connecting the servodrive to the motor, it is
essential that the servodrive power connection supply the holding brake with a
compatible voltage.
Voltage range of servodrive power supply $ V
(1)
(1)
Voltage measured on the X4 connector of the MHDA servodrive
(2)
A relay between brake and drive is necessary.
Continued on next page
Model Motor Brake Present Bias Input Value
MHDA1004•00
MHDA1008•00
MHDA1017•00
MHDA1028•00
No Voltage 24V -5% +15%
Current 0,75 A
Yes Voltage *
Current 2 A max.
MHDA1056•00 No Voltage 24V -5% +15%
Current 1,2 A
Yes Voltage *
Current 2 A max.
* See the following table
Power supply cable lengh
Model 5 m 10 m 15 m 25 m 40 m 50 m 75 m
BPH0552 with brake 22,8...25,8 22,8...25,8 22,8...26,2 22,8...26,1 23...26,2 23,2...26,3 23,5...26,6
BPH075• with brake 22,8...26,1 22,8...26,2 22,9...26,3 23,2...26,4 23,5...26,2 23,7...26,8 24,3...27,1
BPH095• with brake 22,9...26,2 23,1...26,3 23,2...26,4 23,5...26,6 24...26,9 24,3...27,1 25...27,6
BPH115• with brake 23...26,4 23,2...26,4 23,4...26,6 23,7...26,8 24,2...27,1 24,6...27,3 25,4...27,6
BPH142• with brake 23,1...26,4 23,3...26,5 23,6...26,7 24...27 24,7...27,4 25,2...27,6 26,3...27,6
BPH190• with brake 23,6...26,8 24...27 24,3...27,2 25...27,6 26...27,6 26,6...27,6 impossible
(2)
To Next Page