9
Hazards, Warnings and Guidelines, continued
Additional Safety
Guidelines
Read this documentation and adhere to the safety guidelines contained herein
before engaging in any activities involving the servo drives.
l Ensure that all wiring is in accordance with the National Electrical Code (NEC)
or its national equivalent (CSA, CENELEC, etc.), as well as in accordance with
all prevailing local codes.
l Exercise extreme caution when using instruments such as oscilloscopes, chart
recorders, or volt–ohm meters with equipment connected to line power.
l Handle the servo drives as prescribed herein. Incorrect handling can result in
personal injury or equipment damage.
l Adhere to the technical information on connection requirements identified on
the nameplate and specified in the documentation.
l The servo drives may only be operated in a closed cabinet or enclosure.
Nevertheless, operating conditions must be always respected (as defined
in Appendix A):
- operating temperature range
- pollution degree 2 as defined in EN 50178
- assembly.
Qualified
Personnel
Only properly qualified personnel having extensive knowledge in electrical and
servo drive technologies should install, commission and/or maintain the Lexium
17D servo drives.
To Next Page
Loading...