Gocator Snapshot Sensors: User Manual
Gocator Web Interface • 159
When used with profiles not generated from a section, the Global X measurement returns the
same value as the X measurement, and the Global Yand Global Angle measurements return
0.000.
Type Description
Center Point
The center point of the bounding box.
Corner Point
The lower left corner of the bounding box.
Features
For more information on geometric features, see Geometric Features on page 141.
Parameter Description
Source The sensor that provides data for the tool's measurements.
For more information, see Source on page 135.
Stream The data that the tool will apply measurements to.
In Surface mode, this setting is only displayed when a
section is defined on the surface data.
For more information on sections, see Sections on page 127.
Region The region to which the tool's measurements will apply. For
more information, see Regions on page 136.
Filters The filters that are applied to measurement values before
they are output. For more information, see Filters on page
143.
Decision The Max and Min settings define the range that determines
whether the measurement tool sends a pass or fail decision
to the output. For more information, see Decisions on page
142.
Parameters
Anchor Description
X or Z Lets you choose the X or Z measurement of another tool to
use as a positional anchor for this tool.
Anchoring
A measurement must be enabled in the other tool for it to be available as an anchor. The anchor
measurement should also be properly configured before using it as an anchor.
For more information on anchoring, see Measurement Anchoring on page 145.
Circle
The Circle tool provides measurements that find the best-fitted circle to a profile and measure various
characteristics of the circle. Gocator compares the measurement value with the values in Min and Max
to yield a decision. For more information on decisions, see Decisions on page 142.
To Next Page
Loading...
Need help?
General
