Gocator Snapshot Sensors: User Manual
Protocols • 467
Standard data string for measurements ID 0 and 1:
Decision,0,1
OK,M00,00,D0,M01,01,D0
Standard formatted measurement data with a non-existent measurement of ID 2:
Decision,2
ERROR,Specified measurement ID not found. Please verify your input
Custom formatted data string (%time, %decision[0]):
Decision
OK,1420266101, 0
Health Channel
The following sections list the actions available on the health channel.
Optional parameters are shown in italic. The placeholder for data is surrounded by brackets (<>). In the
examples, the delimiter is set to ','.
Health
The Health command retrieves health indicators. See Health Results on page 437 for details on health
indicators.
Message Format
Command Health,health indicator ID.Optional health indicator instance ...
More than one health indicator can be specified. Note that the health indicator instance
is optionally attached to the indicator ID with a '.'. If the health indicator instance field is
used the delimiter cannot be set to '.'.
Reply OK, <health indicator of first ID>, <health indicator of second ID>
ERROR, <Error Message>
Formats
Examples:
health,2002,2017
OK,46,1674
Health
ERROR,Insufficient parameters.
Standard Result Format
Gocator can send measurement results either in the standard format or in a custom format. In the
standard format, you select in the web interface which measurement values and decisions to send. For
To Next Page
Loading...
Need help?
General
