Gocator Snapshot Sensors: User Manual
Getting Started • 35
Next Steps
After you complete the steps in this section, the Gocator measurement system is ready to be configured
for an application using the software interface. The interface is explained in the following sections:
Management and Maintenance (page 62)
Contains settings for sensor system layout, network, motion and alignment, handling jobs, and sensor
maintenance.
Scan Setup and Alignment (page 74)
Contains settings for scan mode, trigger source, detailed sensor configuration, and performing
alignment.
Models (page 112)
Contains settings for creating part matching models and sections.
Measurement (page 133)
Contains built-in measurement tools and their settings.
Output (page 262)
Contains settings for configuring output protocols used to communicate measurements to external
devices.
Dashboard (page 274)
Provides monitoring of measurement statistics and sensor health.
Toolbar (page 51)
Controls sensor operation, manages jobs, and replays recorded measurement data.
To Next Page
Loading...
Need help?
General
