Gocator Snapshot Sensors: User Manual
Getting Started • 34
2. Power up the new sensor.
The power LED (blue) of the new sensor should turn on
immediately.
3. Enter the new sensor's default IP address (192.168.1.10) in
a web browser.
The Gocator interface loads.
4. Go to the Manage page.
5. Modify the IP address in the Networking category and
click the Save button.
You should increment the last octet of the IP address for
each additional sensor you need to use. For example, if the
IP address of the first sensor you configured is
192.168.1.10, use 192.168.1.11 for the second sensor; use
192.168.1.12 for the third; etc.
When you click the Save button, you will be prompted to
confirm your selection.
6. Power-cycle or reset the sensor.
After changing a sensor's network configuration, the
sensor must be reset or power-cycled before the change
will take effect.
7. Repeat these steps for each additional sensor.
To Next Page
Loading...
Need help?
General
