LMI Technologies Gocator 3210 User Manual

Gocator Snapshot Sensors: User Manual
Gocator Device Files • 385
You can access part models in user-created job files in non-volatile storage, for example,
"productionRun01.job/model1.mdl". You can only access part models in user-created job files using path
notation.
See the following sections for the elements contained in a model.
Part models contain the following subcomponents. You can access the subcomponents using path
notation, for example,"productionRun01.job/myModel.mdl/config.xml".
Element Type Description
Configuration config.xml Model configuration XML. It is always present. (See
Configuration on the
next page.)
Edge Points edge-height-
top
Edge points for the top heightmap. (See
Edge Points below
.)
Edge Points edge-height-
bottom
Edge points for the bottom heightmap.
Edge Points edge-
intensity-top
Edge points for the top intensity map.
Edge Points edge-
intensity-
bottom
Edge points for the bottom intensity map.
Part Model Child Elements
The edge points file exists only when the model contains the source data for the edge points.
Edge Points
Field Type Offset Description
id 16s 0
Sender ID
-1 – Part matching
source 8s 2
Source
0 – Model
1 – Target
imageType 8s 3
Image type
0 – Height map
1 – Intensity map
imageSource 8s 4
Image source
0 – Top
1 – Bottom
width 32u 5 Width of model space, in units of xScale
length 32u 9 Length of model space, un units of yScale
xScale 32u 13 X scale (nm)
Edge Points Data

LMI Technologies Gocator 3210 Specifications

General

Brand	LMI Technologies
Model	Gocator 3210
Category	Accessories
Language	English