This product is in conformity with the EMC requirements as for the directive
2004/108/CE
This product is intended to operate in industrial locations; it is not intended for connections to a
public mains network but is intended to be connected to a power network supplied from a high
or medium voltage transformer.
This product is in conformity with the “Electrical Safety” requirements as for the directive
2006/95/EC
SAFETY WARNINGS
Follow the grinder manufacturer’s safety procedures.
Follow all safety procedures at the gauge system location.
There are NO Customer serviceable parts inside the P7WB. Always call technical service
MANUFACTURER: Marposs S.p.A.
ADDRESS: Via Saliceto 13, Bentivoglio (BO) Italy
www.marposs.com
SYSTEM SOFTWARE: V4.4
P7WB SYSTEM – MODEL: 885YW______________
HARDWARE CODE: 885_________________
SOFTWARE CODE: CM168______________
MANUAL CODE NO.: D291W001UD
DATE OF ISSUE: May 2005
EDITION: April 2009
ISSUED BY: Marposs S.p.A., Via Saliceto 13, Bentivoglio (BO) Italy
MARPOSS S.p.A. does not take on the obligation of notifying possible further changes to the product.
The descriptions reported in this book do not authorize any tampering by non-authorized personnel.
The warranty on the equipment will decay if such tampering is found.
© Copyright MARPOSS S.p.A. 2005-2009
To Next Page
Loading...