marposs P7WB - Gap & Crash Control Setting (Automatic Mode); Page for Gap & Crash Controls Setting

– Programming Manual 23. Gap & Crash Function 151
23.2. Gap & Crash control setting
Setting, in Automatic mode, of GAP and CRASH controls.
In Automatic mode select folder Inputs & Outputs and Press .
Press to select the icon of
GAP&Crash function. Press
.
Press
Setting of Gap & Crash controls
Section 23.2.2 page 3 and 23.2.3
page 3.
23.2.1. Page for GAP and CRASH controls setting
This section describes the elements for GAP and CRASH controls setting.