marposs P7WB - Programming Crash Control Data

90 13. Programming – Programming Manual
13.4.4. Programming Crash control data
Page B4 of the “Programming” folder menu map (section 8.2, page 3).
Crash control limit
Setting of the trigger limit (S2) of Crash control. The value programmed must always
be intended as absolute.
To define the value proceed as follows (Manual operating mode – Gap environment):
 Perform a cycle to detect the maximum noise value.
 Repeat the procedure a few times.
 The value of the Crash limit must be 6-10 dB higher than the maximum detected
noise values.
Setting range for S2: 0 to 99.9 decibel (resolution 0.1 decibel).
Value programming: press to highlight the involved field, press or to
view the desired value, then to confirm.
Delay on Crash control limit
The Crash control triggers when the noise level exceeds the limit programmed with
S2 for a time longer than programmed in this stage (time T2).
Setting range for (T2): 0 to 9.999 seconds (resolution 0.001 seconds).
Value programming: press to highlight the involved field, press or to
view the desired value, then to confirm.
Crash control
trigger modality
Crash control limit
Delay on Crash
control limit
Crash control self-locking