– Programming Manual 13. Programming 91
Crash control trigger modality
The Crash output control is triggered when the noise level exceeds limit
S2.
The Crash output control is triggered when the noise level drops below
limit S2.
Data programming: press to highlight the involved field, press or to view
the desired condition, then to confirm.
Crash control self-locking
The Crash control can be either self-locked or not.
Self-locked control. Once supplied, the Crash output control is reset only
at the successive Crash control enabling.
NON self-locked control. The Crash output control is reset when the noise
level drops below the S2 trigger limit.
Data programming: press to highlight the involved field, then press to define
the status of the data.
noise
noise
To Next Page
Loading...