– Programming Manual 13. Programming 93
Note: With the RPM datum enabled the procedure of manual balancing with
weight cannot be correctly performed (section 10.2, page 3).
Data programming: press to highlight the involved field, then:
method 1
press or to view the desired value, then press to confirm.
method 2
1. press
2. press to highlight the digit that needs programming
3. press or to view the desired value
4. repeat steps 2 and 3 for each digit, then press to confirm the value.
Note: The RPM Min value must be lower than RPM Max otherwise "ERROR 4"
will be shown at the exit of programming.
To Next Page
Loading...