Page 202
Appendix| Control Menu
optoNCDT 2300
Load /
save
settings
Setup no.: 1 / 2 / 3 ... 8 Selection of the set of parameters to be load/save. The user selects a num-
ber when loading/saving a complete configuration. Allows fast duplicating
of parameter sets.
Keep interface
settings
Checkbox You should load the interface settings only when the sensor is operated
on different networks respectively with different baud rates of the RS422
interface.
Activate Button If you press Activate the upper selected parameter set is loaded from the
internal memory of the sensor.
Save setup Button The current sensor settings are stored in the selected parameter set in the
internal memory of the sensor.
To Next Page
Loading...
