STEERING ± Power Steering Gear Box Box and Linkage
37A-23
AF" RACK STOPPER/RACK BUSHING ASSEMBLY/
RACK BUSHING/OIL SEAL/O-RING/RACK
REMOVAL
1. Remove the rack stopper, rack bushing, oil seal and O-ring
together by pulling out the rack gently.
2. Partially bend the oil seal to remove from the rack bushing.
Caution
Use care not to damage the oil seal press-fitting
surface of the rack bushing.
AG" OIL SEAL REMOVAL
Use a pipe or the like to pull out the oil seal.
REASSEMBLY SERVICE POINTS
" AA GEAR HOUSING MOUNTING RUBBER
INSTALLATION
1. Install the gear housing mounting rubber on the rack
housing so that the dimension shown is achieved.
NOTE
The gear housing mounting rubber can be installed
regardless of the installation direction of the slit.
2. Apply specified adhesive to the slit of the gear housing
mounting rubber.
Specified adhesive:
3M ATD Part No.8155 or equivalent
Rack bushing
Oil seal
Gear housing
Pipe
Slit
Slit
37.5 mm
37.5 mm
Gear housing
mounting rubber
Gear housing
mounting rubber
<R.H. drive vehicle>
<L.H. drive vehicle>
To Next Page
Loading...
