STEERING ± Power Steering Gear Box Box and Linkage
37A-24
" BA OIL SEAL INSTALLATION
" CA RACK ASSEMBLY INSTALLATION
1. Apply repair kit grease to the teeth of the rack assembly.
Caution
Use care not to close the vent hole in the rack with
grease.
2. Cover the serrations of the rack assembly with the special
tool.
3. Apply specified fluid to the outer surfaces of the special
tool, seal ring and O-ring.
Specified fluid:
Automatic transmission fluid
DEXRON or DEXRON II
4. Slowly insert the rack covered with the special tool from
the power cylinder side of the gear housing.
Caution
Carefully push in the rack with the oil seal centre and
the special tool end matched. This is to avoid the
retainer spring coming off.
" DA OIL SEAL/RACK BUSHING/RACK BUSHING
ASSEMBLY INSTALLATION
1. Apply specified fluid to the outer surface of the oil seal.
Using the special tool, press in the oil seal until it is flush
with the bushing end face.
Specified fluid:
Automatic transmission fluid
DEXRON or DEXRON II
MB991197
Gear housing
Oil seal
MB991199
Vent hole
Seal ring, O-ring
MB991213
Oil seal
MB990925
(MB990927)
Oil seal
O-ring
Rack
bushing
To Next Page
Loading...
