6. General Procedures - MFC Test Program Overview
194 Morgana DocuMaster MFC - Service Manual
6.3 MFC Test Program Overview
The MFC Test program is a computer program that you can use to do diagnostic
analysis on the MFC creaser and drive control system. Also, the MFC Test program
has a built-in calibration program, known as the MCW (Machine Configuration Wizard),
which must be used to calibrate the creaser module.
The MFC Test program has been designed to run
on MS Windows XP (preferable) and
MS Windows 7 operating systems.
6.3.1 Get the MFC Test Program
The MFC Test program is supplied as a self-extracting zip file. Get the MFC Test
program from Morgana on USB Storage Disc or download the program from the
internet at
http://www.morgana.co.uk
The dealer portal area of the Morgana website has restricted access. Contact Morgana
Systems Limited if you need the password.
Copy the MFC Test Program to the Desktop on
your computer.
Figure 6.1 MFC Test Program Icon
To Next Page
Loading...
