DCS Command System User’s Guide
Menu Operations - Systems
Track Setup: (cont’d)
Add Track: (cont’d)
Add Z4K Track
5. Look at the back of the Z-4000 to see
which is track 1 and which is track 2.
Scroll within the LCD to the track you
want to run and press the thumbwheel to
select.
6. The LCD prompts you to name the
track, and an alphanumeric character set is
displayed. Use the thumbwheel to scroll
through the character set, and when the
character you want to type next is bracket-
ed, press the thumbwheel to select it. You
may give the track a name up to 16 char-
acters long. Select the “D” at the end of
the character set to signify that you are
done with this function.
7. Follow the LCD’s prompt to “Turn on
Z4K. When PG PG appears (in the
transformer’s LED display) press E-stop
(on the DCS handheld).”
For instructions on running a conventional mode
engine on a Z-4000 track, please see the
“Universal Locomotive Control: Conventional
Mode” section of the “Universal Locomotive and
Accessory Operation” chapter.
64
To Next Page
Loading...
