Plug-in Menu Entry Description
Paste Loads into the current slot the Plug-in and all its settings that
were cut or copied from another slot. This notably allows you to
use a Plug-in in different locations (Sounds, Groups, Master)
with the same settings.
Preset Management
Open… Allows you to open a Plug-in preset you have previously saved.
Save As… Allows you to save the current Plug-in settings as a preset for
later use. This preset will appear in the Browser.
Save As Default… (only
when a Native Instruments
or External Plug-in is
loaded)
Allows you to save the current Plug-in settings as a default
preset. This default preset will be recalled each time you load
the Plug-in from the Plug-in menu.
Note that the first two submenus Native Instruments and External only show the Plug-
ins that are enabled in the Plug-ins page of the Preferences panel. For more on this, see
section ↑2.6.6, Preferences – Plug-ins Page.
The edit commands (Cut, Copy, and Paste) and preset management commands (Open,
Save As…, and Save As Default…) available at the bottom of the Plug-in menu will be
covered in section ↑6.1.7, Moving Plug-ins and ↑6.1.9, Saving and Recalling Plug-in
Presets, respectively.
6.1.3.1 Loading, Removing, and Replacing a Plug-in on your Controller
On the MASCHINE MIKRO controller, do the following:
1. Press CONTROL to enter Control mode.
2. Select the Sound, Group or the Master where you want to load, remove or replace a Plug-
in (see section ↑2.3.1, Setting the Focus on a Group or a Sound).
3. Press NAV + F3 (PLUG-IN) to display the Plug-in slots of the selected Sound, Group or
the Master.
Working with Plug-ins
Plug-in Overview
MASCHINE MIKRO - Manual - 270
To Next Page
Loading...
