Using the EDIT Page on Your Controller
►
In Sampling mode, press NAV + pad 14 to access the EDIT page. You can also hold NAV
and turn the Control encoder.
The EDIT page looks as follows:
The EDIT page on the controller.
The display shows you the waveform of the selected Sample. You can adjust the waveform view
as follows:
1. Press and hold the VIEW button to enter View mode. You can also pin the View mode so
that you can release VIEW and stay in View mode (see ↑2.3.6, Pinning a Mode on Your
Controller).
2. Press F2 to select WAVE.
3. Press pad 2/6 to zoom in on the waveform of the Sample and pad 1/3 to scroll through it.
4. When you are done, don’t forget to press the lit VIEW button again to leave View mode
and switch back to Sampling mode.
The waveform provides the following additional information:
▪ Above the waveform, the information bar indicates the name and length of the Sample.
▪ The Sample can be played back at any time by pressing the corresponding pad on your
controller. When the Sample is played back, the playhead indicator (vertical line) shows
you the current play position within the waveform on the right display.
▪ The grayed out and highlighted parts on the waveform indicate you where the play and se-
lection ranges are located (see details below).
The parameters available at the bottom of the display are spread over two pages:
Sampling and Sample Mapping
Editing a Sample
MASCHINE MIKRO - Manual - 778
To Next Page
Loading...
