1. Press NAV + Left/Right Arrow button to access the desired page of parameters.
2. Press the Left/Right Arrow buttons to select the parameters within each page.
3. To adjust the selected parameter, turn the Control encoder. For continuous parameters,
press and turn the Control encoder to adjust the value in finer increments.
Page 1 – PLAY RANGE Parameters
The parameters in the PLAY RANGE page allow you to adjust the range that will be played
when you trigger a note.
The EDIT page on the controller, page 1 of 2: adjusting the play range of the Sample.
Parameter
Description
START Adjusts the start point of the play range in the Sample.
END Adjusts the end point of the play range in the Sample.
Press and turn the Control encoder to adjust the parameters in finer increments.
In the waveform on the display, the regions outside the play range are grayed out.
If a loop has been defined in the Sample, it is also indicated on the waveform. Loops
can be created and adjusted in the ZONE page — see section ↑14.5.4, Selecting and
Editing Zones in the Map View. Note that the loop will always stay within the region de-
fined by the start and end points of the Sample. Therefore, when moving the Sample’s
start and end points closer to each other, keep in mind that it might also shrink the
loop!
Sampling and Sample Mapping
Editing a Sample
MASCHINE MIKRO - Manual - 779
To Next Page
Loading...
