Page 2 – SELECTION RANGE Parameters
The parameters in the SELECTION RANGE page allow you to adjust the range to which audio
processing functions will be applied.
The EDIT page on the controller, page 2 of 2: adjusting the selection range of the Sample.
Parameter
Description
START Adjusts the start point of the selection range in the Sample.
END Adjusts the end point of the selection range in the Sample.
Press and turn the Control encoder to adjust the parameters in finer increments.
In the waveform on the display, the selection range is highlighted.
Changing the play range automatically resets the selection range to the new play range.
Audio Editing
The EDIT page provides several audio editing functions to process your Sample. Available via
the F1–F3 buttons above the right display, these functions are described in detail in the next
section ↑14.3.2, Audio Editing Functions.
Sampling and Sample Mapping
Editing a Sample
MASCHINE MIKRO - Manual - 780
To Next Page
Loading...
