Installing the Operating System with Express Setup 5-3
Express Setup uses "the Configuration Diskette". The the Configuration Diskette is a floppy disk that includes the
configuration information for the server setup used in the automatic installation mode. Express Setup will perform all
the process of the setup using the information in the floppy disk. During this procedure, you do not have to be in front
of the server to confirm the state of the setup. Also, using the same the Configuration Diskette used before allows you to
re-setup your server with the same condition as before.
Express Setup includes two types of installation method.
îš„ Quick start
Quick start uses the the Configuration Diskette on which the configuration parameters for the server setup are
pre-loaded before starting the Express Setup. The configuration parameters are loaded by using the
Configuration Diskette Creator (see Chapter 6).
îš„ Normal start
Normal start is to create the the Configuration Diskette after starting the Express Setup.
NOTES:
îš„ Use the blank disk in the accessory box to create the Configuration Diskette.
îš„ You can create the Configuration Diskette in advance using "the Configuration Diskette Creator"
included in EXPRESSBUILDER.
îš„ If you create the Configuration Diskette in advance, you can define the items that have to be input
or selected during Express Setup. (You can also create or modify the setup information restored in
the Configuration Diskette during Express Setup.) If you have a computer other than your server that
is running with Windows 95/98/Me/XP, Windows NT 3.51 or later, Windows 2000, or Windows
Server 2003, we recommend you to edit setup information from the computer in advance using the
Configuration Diskette Creator.
For more information on how to create the Configuration Diskette using the Configuration Diskette
Creator, see Chapter 6.
To Next Page
Loading...
Need help?
General
