EasyManuals Logo

NEC Express5800 110Ej User Manual

NEC Express5800 110Ej
357 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
1-4 Notes on Using Your Server
Power Supply and Power Cord Use
WARNING
Do not hold the power plug with a wet hand.
Do not disconnect/connect the plug while your hands are wet. Failure to follow this warning may
ause an electric shock.
c
CAUTION
Plug in to a proper power source.
Use a proper wall outlet. Use of an improper power source may cause a fire or a power leak.
Do not install the server where you need an extension cord. Use of a power cord that does not
meet the power specifications of your server may heat up the cord and cause a fire.
Do not connect the power cord to an outlet that has an illegal number of connections.
The electric current exceeding the rated flow overheats the outlet, which may cause a fire.
Insert the power plug into the outlet as far as it goes.
Heat generation resulting from a halfway inserted power plug (imperfect contact) may cause a fire.
Heat will also be generated if condensation is formed on dusty blades of the halfway inserted plug,
increasing the possibility of fire.
Use an authorized power cord only.
Use only the power cord that comes with your server. Use of an unauthorized power cord may
cause a fire when the electric current exceeds the rated flow.
Also, observe the following to prevent an electric shock or fire caused by a damaged cord.
Do not stretch the cord harness.
Do not pinch the power cord.
Do not bend the power cord.
Keep chemicals away from the power cord.
Do not twist the power cord.
Do not place any object on the power cord.
Do not bundle power cords.
Do not alter, modify, or repair the power cord.
Do not secure the power cord with staples or equivalents.
Do not use any damaged power cord. (Replace a damaged power cord with a new one of the
same specifications. Ask your service representative for replacement.)
Do not use the attached power cord for any other devices or usage.
The power cord that comes with your server is designed aiming to connect with this server and
to use with the server, and its safety has been tested. Do not use the attached power cord for
ny other purpose. Doing so may cause a fire or an electric shock. a

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NEC Express5800 110Ej and is the answer not in the manual?

NEC Express5800 110Ej Specifications

General IconGeneral
Form FactorTower
RAMUp to 32GB DDR3
StorageSATA
RAIDRAID 0, 1
NetworkDual Gigabit Ethernet
Hard DriveUp to 4 x 3.5" SATA HDD

Related product manuals