F-14 Installing Windows 2000
Installing SCSI Controller Driver
If you utilize SCSI controller driver (Adaptec 29320), install it according to the following procedure:
1. Start [Device Manager] from [Start] menu → [Control Panel] → [Administrative Tools] → [Computer
Management].
2. Double-click the SCSI Controller driver which Device Manager lists as unknown device.
3. Click [Update Driver].
4. When the "Update Device Driver Wizard" appears, select "Install from a list or specific location [Advanced]"
and click [Next].
5. Select "Don't search. I will choose the driver to install" and click [Next].
6. Click [Have Disk..].
7. Insert "Windows 2000 OEM-DISK for EXPRESSBUILDER" into the floppy disk drive, enter "a:\" into "copy
manufacturer's file from:" and click [OK].
8. Specify the following driver and click [Next].
[Adaptec SCSI Card 29320ALP - Ultra320 SCSI] (When the Adaptec 29320 board is installed.)
The installation of the driver is completed.
Restart the system according to the message appeared on the screen.
SETTING FOR COLLECTING MEMORY DUMP
(DEBUG INFORMATION)
Set for collecting memory dump using the procedure described in Chapter 5.
To Next Page
Loading...
Need help?
General
