3-4 Setting Up Your Server
SELECTING SERVER SITE
Read the following precautions before selecting a suitable site for your server. The following describes installation of
the server and connections to the server.
CAUTION
Observe the following instructions to use the server safely. Failure to follow
these instructions may cause a fire, personal injury, or property damage. See
pages 1-3 to 1-8 for details.
Never attempt to lift the server only by yourself.
Do not install the server in any place other than specified.
The following figure illustrates a site suitable for installing the server.
* It is recommended that the server should be used in a room where
temperature is in the range between 15 to 25ºC.
Clean and tidy room
Allow clearance of at least 150 mm in
front of and behind the server.
100 to 120 Vac/200 to 240
Vac parallel bi-polar wall
power outlet with the
ground line.
Room th
following
<While o
Temper
Humidity
Temper
Atmosph
<While
Temper
Humidity
Temper
Atmosph
at satisfies the
conditions: *
perating>
ature: 10 to 35ºC
: 20 to 80%
ature gradient: ±10ºC/h
ere: 749 to 1040 hpa
halting>
ature: 5 to 40ºC
: 10 to 80%
ature gradient: ±15ºC/h
ere: 749 to 1040 hpa
Close enough to connect the
mouse and the display.
Install the server on
a flat, ri