Upgrading Your Server 9-5
INSTALLATION OR REMOVAL PROCEDURE
Install or remove a component from the server in the following procedure.
Left Side Cover
The left side cover should be removed to access to built-in devices in the server.
CAUTION
The qualified service representative can only install or remove the components
described in this subsection. To avoid personal injury or electrical shock, contact
your service representative when your need to install/remove the internal
components.
Removal
Remove the left side cover in the following procedure.
1. See the section "Preparing for Installation and Removal" described earlier to prepare.
2. Unlock the left side cover if required.
3. Fold the four stabilizers at the bottom of the server toward inside.
4. Lay the server so that its right cover faces the floor.
To Next Page
Loading...
Need help?
General
