F-4 Installing Windows 2000
INSTALLING WINDOWS 2000
Preparations for Installation
îš„ EXPRESSBUILDER CD-ROM
îš„ Microsoft Windows 2000 Server (CD-ROM)
îš„ Windows 2000 Service Pack (CD-ROM)
îš„ User's Guide
îš„ Getting Started
îš„ Windows 2000 OEM-DISK for EXPRESSBUILDER
Creating "Windows 2000 OEM-DISK for EXPRESSBUILDER"
Before installing, create Windows 2000 OEM-DISK for EXPRESSBUILDER.
NOTE: If you have already "Windows 2000 OEM-DISK for EXPRESSBUILDER" for the
server which you are going to install Windows 2000, you do not need to create it again.
You can create Windows 2000 OEM-DISK for EXPRESSBUILDER with the following two procedures.
îš„ Create from the menu which appears when running a server with EXPRESSBUILDER.
If you have only this server to create Windows 2000 OEM-DISK for EXPRESSBUILDER, use this
procedure.
If Windows Server 2003 or Windows 2000 can be operated on another server, you can use the other procedure
described later.
Follow the steps below.
1. Prepare one 3.5-inch floppy disk.
2. Turn on your server.
3. Insert the EXPRESSBUILDER CD-ROM into the CD-ROM drive of the server.
4. Press the RESET switch or press Ctrl, Alt and Delete to reboot the server.
(You may also turn off and then on again to reboot the server.)
The system will boot from the CD-ROM and EXPRESSBUILDER starts.
5. Select [Create Support Disk] from [Tools].
6. Select [Windows 2000 OEM-DISK for EXPRESSBUILDER] from [Create Support Disk] menu.
To Next Page
Loading...
Need help?
General
