5-6 Installing the Operating System with Express Setup
Windows Server 2003
Express Setup can install the Windows Server 2003 operating system. However, note the following:
IMPORTANT:
îš„ Before starting the installation, complete all the process of adding the optional device and the setup
of the server mainframe (BIOS and optional board specification)
îš„ A document for installing Windows Server 2003 is also attached to the other software package
which we sell separately, but refer to this User’s Guide when you install Windows Server 2003 on
this model.
îš„ After completing Express Setup, see "Setup for Solving Problems" described later to specify the
settings for trouble recovery such as "Specifying Memory Dump".
Installing on the Mirrored Volume
If you want to install Windows Server 2003 on the volume that is mirrored using "Disk Management", invalid the
mirroring before operating the installation to set back to the basic disk, and valid the mirroring again after the
installation has completed.
All this can be done from "Disk Management" in "Computer Management".
Connecting MO Device
If you install Windows Server 2003 with a MO device connected, the installation may not complete normally. In such a
case, detach the MO device and then re-install the system from the beginning.
Media such as DAT
During the OS installation, do not attach media that are not necessary for the OS installation to the system, such as
DAT.
Connecting Hard Disk Drive
Connect data hard disk drives only after installing the OS.
If you create multiple logical drives in your system, refer to "Re-installing the operation system when multiple logical
drives exist" (Appendix D).
To Next Page
Loading...
Need help?
General
