8-12 Troubleshooting
POST fails to complete:
8 Is the DIMM board installed?
→ At least one DIMM boards are required for operation.
8 Is the memory size large?
→ The memory check may take a few seconds if the memory size is large. Wait for a while.
8 Did you perform any keyboard or mouse operation immediately after you started the server?
→ If you perform any keyboard or mouse operation immediately after start-up, POST may accidentally
detect a keyboard controller error and stops proceeding. In such a case, restart the server once again.
Do not perform any keyboard or mouse operation until the BIOS start-up message appears when you
restart the server.
8 Does the server have contains appropriate memory boards or PCI devices?
→ Operation of the server with unauthorized devices is not guaranteed.
Fail to access to internal or external devices (or such devices fail to operate):
8 Are cables properly connected?
→ Make sure that the interface cables and power cord are properly connected. Also make sure that the
cables are connected in the correct order.
8 Is the power-on order correct?
→ When the server has any external devices connected, power on the external devices first, then the
server.
8 Did you install drivers for connected optional devices?
→ Some optional devices require specific device drivers. Refer to the manual that comes with the device
to install its driver.
8 Is BIOS configuration correct?
→ Some devices connected to the serial or parallel port may require I/O port address or operation mode
settings. Refer to the manual that comes with the board for details to make correct settings.
To Next Page
Loading...
