Troubleshooting 8-17
The system does not restart automatically when a stop error occurs, though the system is adjusted to
automatically restarting:
→ When the system does not restart automatically, restart it manually.
The system restarts automatically when a stop error occurs, though the system is NOT adjusted to automatically
restarting:
→ There is no problem about this issue.
Check the System Event Log to confirm that STOP error occurred.
Cannot turn the power OFF at the blue screen:
→ If you want to turn off the power at the blue screen, execute forced shutdown (forced shutdown:
continue to press POWER/SLEEP switch for 4 seconds). The power will not be turned off if you press
the switch for less than 3 seconds.
The PXE boot (network boot) fails or the server is not found on the network:
8 Is the cable connected properly?
→ Connect the proper cable to the network port on the rear of the Server. In addition, make sure that the
used cable conforms to the network interface standard.
8 Is BIOS configuration correct?
→ The internal LAN controller may be disabled with the BIOS Setup utility of the server. Check the
setting with the BIOS setup utility.
8 Have the protocol and service already configured?
→ Install the distinctive network driver for the server. Make sure that the protocol, such as TCP/IP, and
services are properly specified.
8 Is the transfer speed correct?
→ Open the network property dialog box in control panel to specify the link speed and duplex value the
same as the value specified for HUB.
To Next Page
Loading...
Need help?
General
