Upgrading Your Server 9-17
Slots to install the PCI board
PCI Slot
#1 #2 #3 #4 #5
Product name
64-bit /
133MHz
PCIe
x8
PCIe
x1
32-bit /
33MHz
Slot size Full-height
Voltage 3.3V x8 socket 5V
Available board size Short – Long
Note
Ultra160 SCSI controller
√ √
– – –
Adaptec 29320 SCSI controller
√ √
– – –
SX4100 S-ATA disk array
controller
√ √
– –
√
MegaRAID SCSI 320-1 disk
array controller
√ √
– – –
*2
Additional DAC battery (SATA)
√ √
– –
√
*3
1000BASE-T, PCI, 1Ch Server
adapter
√ √
– – –
1000BASE-SX, PCI-X, 1Ch
Server adapter
√ √
– – –
1000BASE-T Dual Port Server
adapter
√ √
– – –
*4
1000BASE-T, PCI-X, Server
adapter
– –
√ √
–
Additional RS-232C connector
kit
– –
√ √ √
*5
√: Available, –: Unavailable
*1 Up to two cards can be installed.
*2 Only one card can be installed. All hard disk drives must accept the same interface.
*3 Additional battery for the SX4100 Serial-ATA Disk Array Controller board
*4 Only one card can be installed (with AFT, up to two cards can be installed).
*5 Required to connect the console when Remote Management Card is installed.
To Next Page
Loading...
