9-28 Upgrading Your Server
1. See the section "Preparing for Installation and Removal" described earlier to prepare.
2. Open the levers at the both ends of the socket for the DIMM to be removed.
The lock is released to allow the DIMM to be removed.
3. Remove the DIMM.
4. Assemble the server.
5. Turn on the power of the server. Make sure that no error message appears in the POST.
If POST displays an error message, take a note on the message and see the POST error messages listed in
Chapter 8.
6. Run the BIOS SETUP and select [Advanced] → [Memory Configuration] → [Memory Retest] → [Enabled]
to clear the error information of the removed DIMM. (See Chapter 4 for details.)
7. Select "Yes" for [Reset Configuration Data] on the [Advanced] menu.
This is required to update the hardware configuration information. See Chapter 4 for details.
8. If Windows Server 2003 or Windows 2000 is in use, set the paging file size to the recommended value or a
greater value. See Chapter 5 for details.
To Next Page
Loading...
Need help?
General
