9-36 Upgrading Your Server
9. Slowly insert the CD-ROM drive into additional slot 1 with the release tabls on both sides of the drive.
Push the drive until a click occurs to lock it.
10. Connect the interface and power cables to the 5.25-inch device installed from one side of the server.
See Chapter 10 for details.
NOTE: Connect the interface cable of the floppy disk drive so that the end with the red
line indicating pin 1 faces the mother board.
CD-R
Flopp
OM drive
REAR
FRONT
y disk drive
Red line
To Next Page
Loading...
