2-22 General Description
Use of the CD-ROM
Keep the following notes in mind to use the CD-ROM for the server:
The playback of disks that do not conform to the standard is not guaranteed.
Do not drop the CD-ROM.
Do not place anything on the CD-ROM or bend the CD-ROM.
Do not attach any label onto the CD-ROM.
Do not touch the signal side (the side on which nothing is printed) with your hand.
Place the CD-ROM with its printed side upward and gently put it on the tray.
Do not scratch the CD-ROM or write anything directly on it with a pencil or ball-point pen.
Keep the CD-ROM away from cigarette smoke.
Do not leave the CD-ROM in a high-temperature place (e.g., place exposed to direct sunlight or close to a
heater).
When dust or fingerprints are attached on the CD-ROM, wipe the CD-ROM from its center to edge with a dry
soft cloth slowly and gently.
Use the CD cleaner to clean the CD-ROM. Do not use record spray/cleaner, benzene, or thinner.
Keep the CD-ROM in a CD-ROM case when not in use.
If the CD-ROM emits large noise in the CD-ROM drive, remove the CD-ROM and insert it back again.
To Next Page
Loading...
